shrink wrapping machine knowledge
Labels shrink machine' installation and operation
add time ：2013-10-21 quote link：http://www.shrinkmachine.cn/new_show452.html
1, heat shrinkable machine is positioned on the flat ground, remove the outer package.
2, to the personal safety of the operator, in the thermal contraction machine before use must be grounded in accordance with the regulations, and ensure the good contact.
3, according to the supply voltage regulation shrinking machine (not to the wrong), and then connect the power.
Method of operation
A, the power switch on the electrical panel.
B, open the heating switch, according to the thickness of the film, will be placed in the appropriate temperature, generally about 130 degrees.
C, this is done, let the machine run (pre) 5-10 minutes later, open the thermal circulation fan switch on the front panel, this can be contracted work.
Common status
During contraction, if found excessive wrinkle,lable shrink machine, shrink labels room temperature is too low or conveying speed is too fast, can increase the temperature or reduce conveying speed. On the contrary, such as the emergence of shrinkage cracking phenomenon, the temperature is too high or conveying speed is too slow, can be adjusted according to the actual situation, because the temperature and speed of mutual restraint, and sometimes may be repeated several times to adjust, can meet the requirements.
2, to the personal safety of the operator, in the thermal contraction machine before use must be grounded in accordance with the regulations, and ensure the good contact.
3, according to the supply voltage regulation shrinking machine (not to the wrong), and then connect the power.
Method of operation
A, the power switch on the electrical panel.
B, open the heating switch, according to the thickness of the film, will be placed in the appropriate temperature, generally about 130 degrees.
C, this is done, let the machine run (pre) 5-10 minutes later, open the thermal circulation fan switch on the front panel, this can be contracted work.
Common status
During contraction, if found excessive wrinkle,lable shrink machine, shrink labels room temperature is too low or conveying speed is too fast, can increase the temperature or reduce conveying speed. On the contrary, such as the emergence of shrinkage cracking phenomenon, the temperature is too high or conveying speed is too slow, can be adjusted according to the actual situation, because the temperature and speed of mutual restraint, and sometimes may be repeated several times to adjust, can meet the requirements.
