shrink wrapping machine knowledge
Safety precautions of sleeve shrink machine
add time ：2013-10-28 quote link：http://www.shrinkmachine.cn/new_show454.html
Semi automatic sleeve shrink machine especially PE film sleeve sealing and cutting machine (covering machine) attention to security matters during the use of the following points:
1 When sleeve shrink machine is running, the maximum input power line AC220V under current should be 6A.
2 Sleeve machine must be reliably grounded, in order to protect the personal safety
3 No corrosive gas around environment, so as to avoid the adverse sleeve shrink machine
4 Sleeve shrink machineSuff systolic machine work, operator's hands and other parts do not allow the operation of the site and machine contact, especially in a sealing cutter row is dangerous.
5 Electrical panel, sealing and cutting time relay of the timing, must obey the principle must be from low to high.
6 The machine just started to work, because of low temperature heat sealing parts, thin film may be difficult to cut, but after several cycles to work, into the normal working state can be time the machine just started to work, because of low temperature heat sealing parts, thin film may be difficult to cut, but after several cycles to work, into the normal working state.
1 When sleeve shrink machine is running, the maximum input power line AC220V under current should be 6A.
2 Sleeve machine must be reliably grounded, in order to protect the personal safety
3 No corrosive gas around environment, so as to avoid the adverse sleeve shrink machine
4 Sleeve shrink machineSuff systolic machine work, operator's hands and other parts do not allow the operation of the site and machine contact, especially in a sealing cutter row is dangerous.
5 Electrical panel, sealing and cutting time relay of the timing, must obey the principle must be from low to high.
6 The machine just started to work, because of low temperature heat sealing parts, thin film may be difficult to cut, but after several cycles to work, into the normal working state can be time the machine just started to work, because of low temperature heat sealing parts, thin film may be difficult to cut, but after several cycles to work, into the normal working state.
